Skip to content
Log in

Monitor stations across the outlet

On this page

The outlet stations board shows every register in the outlet and the stations attached to each one, with live ticket counts. Use it when you are running the floor rather than working one station: to see where work is banking up, to take a station out of service when the printer fails or the staff leave, and to move stations between registers.

Before you start

Read the board

Open the board from the sidebar entry your admin added. It is headed with the outlet name, such as Riverside stations, and shows one column per register.

  • Your own register comes first, headed Your register with its name, and each column shows when that register was last active.
  • A register with no stations shows No stations assigned. These columns still act as a destination when you move a station.
  • Stations that are not attached to any register are collected in an Inactive stations column.
  • A register with more than one station has an All tickets button that opens its combined ticket list.

Each station row shows live counts for tickets that are requested, preparing, and ready, plus an arrow naming where its tickets are going if they are being redirected. Tap a row to open that station’s tickets.

Take a station out of service and bring it back

Degrade a station when it cannot work: its printer has failed, or the staff on it have gone.

  1. Open the station.
  2. Select Degrade station from its menu and confirm.

New tickets route to the station’s fallback from that moment, and a banner names where they are going. Tickets already at the station stay there, so move them if they also need to go elsewhere. See work station tickets.

To bring it back, select Restore station and confirm.

:::note There is no permission gating on any of these actions. The confirmation is the only check, so anyone with the board in front of them can degrade or restore a station. :::

Cover a station from this device

Covering means this device also handles another station’s tickets, so they show up here for reprinting and moving.

  1. Select Cover station from the station’s row menu on the board, or Cover a station on the Stations screen when this device has none of its own.
  2. Confirm.

The station joins this device’s list, tagged as covered by you, and its own routing is unchanged. Covering is local to this device, so no other register knows about it.

Covering does not print anything on its own. To print new tickets here as they arrive, select Auto-print new tickets from the station’s menu. Only tickets created after you switch it on print automatically, so an existing backlog is left alone. Stop auto-printing tickets turns it off again.

When the station is back on its feet, select Stop covering this station, which also turns off its auto-printing.

Move a station to another register

  1. Select Move station from the station’s row menu, or Move stations from the board’s header to start without a station chosen.
  2. Choose the station, then the register to attach it to.
  3. Confirm.

To take a station off a register entirely, select Deactivate from its row menu. The station keeps its routing configuration but stops printing anywhere until it is attached to a register again, and it moves to the Inactive stations column.

Station groups are not managed from here. A parent station never appears in a register’s list and cannot be covered, degraded, or moved, because the work always happens at its children.

Status changes are safe to make while the register is offline. The board updates on this device straight away and the change reaches the rest of the outlet when the connection returns.

Was this article helpful?

Was this article helpful?